Wish list?

Post Reply
Navstax
Site Admin
Posts: 33
Joined: Fri Jan 26, 2018 2:58 am

Wish list?

Post by Navstax » Wed Feb 07, 2018 5:21 pm

Let us know what new products and features you would like to see!

MikeCameron
Posts: 22
Joined: Sun Feb 18, 2018 12:38 am

Re: Wish list?

Post by MikeCameron » Mon Feb 19, 2018 6:29 pm

an autopilot to go along with the Bendix King avionics stack.

Mike

bytes2001
Posts: 1
Joined: Sun May 06, 2018 1:44 pm

Re: Wish list?

Post by bytes2001 » Sun May 06, 2018 6:24 pm

I second the need for an autopilot addition.

bytes2001

fws
Posts: 1
Joined: Mon May 07, 2018 8:42 pm
Location: San Diego, CA USA

Re: Wish list?

Post by fws » Mon May 07, 2018 9:42 pm

Until I get a 3D panel to use these in (plan to get the C310R Redux very soon), I would like to be able to edit the order of the stack in 2D.
They seem to be in a locked order of display.

Would like to be able to use more than just one of the COM/NAV radios. For example if I want COM1 and COM2 and/or NAV1 and NAV2,
I might want to have two KX 165 or two KX 165A installed. Presently I must use one of each.
Frank Safranek

MatzeH84
Posts: 4
Joined: Thu May 10, 2018 10:48 pm

Re: Wish list?

Post by MatzeH84 » Thu May 10, 2018 11:15 pm

Please, please make the DME receiver independent from NAV2. It is possible, as others have shown. I was really expecting that, considering the units cost half the prize (as introduction!) of a full A2A model which includes similar complex units.
And, to make this unit complete, make the GPS input selectable (either have, or don't have it).

An autopilot sure would be great!

Some Garmin units would be great; the GTX transponder series would be a nice addition, also the new GFC autopilot series would be a great retrofit. Would also combine well with the new GTR receivers.

tgavinkelly
Posts: 1
Joined: Sun May 13, 2018 6:41 pm

DHC-3 Otter

Post by tgavinkelly » Thu May 17, 2018 2:00 pm

This would be a good candidate.

Navstax
Site Admin
Posts: 33
Joined: Fri Jan 26, 2018 2:58 am

Re: Wish list?

Post by Navstax » Fri May 18, 2018 10:38 pm

Mil-Viz has just confirmed that their Turbo Otter will support the Kingnav!

Post Reply